 |
Index for
Section 5 |
|
 |
Alphabetical
listing for S |
|
 |
Bottom of
page |
|
sys_attrs_netrain(5)
NAME
sys_attrs_netrain - netrain subsystem attributes
DESCRIPTION
This reference page lists and describes attributes for the Redundant Array
of Independent Network adapters (NetRAIN) (netrain) kernel subsystem. Refer
to the sys_attrs(5) reference page for an introduction to the topic of
kernel subsystem attributes.
nr_debug
A value that enables (1) or disables (0) the logging of NetRAIN debug
messages in syslog kern.log file.
Do not modify the default setting for this attribute unless instructed
to do so by Compaq Computer Corporation support personnel or by patch
kit documentation.
Default value: 0 (disabled)
nr_maxdev
The number of NetRAIN devices allowed on the system. The first NetRAIN
device is nr0.
Default value: 128 (devices)
Minimum value: 0
Maximum value: 512
The maximum nr device number is nr_maxdev - 1. For example, using the
default value of 128, the maximum NetRAIN device number is nr127.
nr_timeout_dead_interface
The time interval or frequency between successive polls of a dead
interface by the Network Interface Failure Finder (NIFF) traffic
monitor thread (nifftmt).
Default value: 6 (seconds)
Minimum value: 0
Maximum value: INT_MAX, or 2 billion
nr_timeout_o
The total amount of time for the nifftmt thread routine to declare an
interface dead (from the GREEN state to the DEAD state).
Default value: 10 (seconds)
Minimum value: 0
Maximum value: INT_MAX, or 2 billion
nr_timeout_t
The time interval or frequency between successive reads of a NetRAIN
interface's counters by the nifftmt thread when the network is
operating normally.
Default value: 4 (seconds)
Minimum value: 0
Maximum value: INT_MAX, or 2 billion
SEE ALSO
sys_attrs(5)
Network Administration
|
Index for
Section 5 |
|
|
Alphabetical
listing for S |
|
 |
Top of
page |
|